Loading... please wait.

C Specification

The line stipple factor and pattern are specified by the VkPipelineRasterizationLineStateCreateInfoEXT::lineStippleFactor and VkPipelineRasterizationLineStateCreateInfoEXT::lineStipplePattern members of the currently active pipeline, if the pipeline was not created with VK_DYNAMIC_STATE_LINE_STIPPLE_EXT enabled.

Otherwise, the line stipple factor and pattern are set by calling vkCmdSetLineStippleEXT:

// Provided by VK_EXT_line_rasterization
void vkCmdSetLineStippleEXT(
    VkCommandBuffer                             commandBuffer,
    uint32_t                                    lineStippleFactor,
    uint16_t                                    lineStipplePattern);


  • commandBuffer is the command buffer into which the command will be recorded.

  • lineStippleFactor is the repeat factor used in stippled line rasterization.

  • lineStipplePattern is the bit pattern used in stippled line rasterization.


Valid Usage
  • lineStippleFactor must be in the range [1,256]

Valid Usage (Implicit)
  • commandBuffer must be a valid VkCommandBuffer handle

  • commandBuffer must be in the recording state

  • The VkCommandPool that commandBuffer was allocated from must support graphics operations

Host Synchronization
  • Host access to commandBuffer must be externally synchronized

  • Host access to the VkCommandPool that commandBuffer was allocated from must be externally synchronized

Command Properties
Command Buffer Levels Render Pass Scope Supported Queue Types Pipeline Type




See Also

Document Notes

For more information, see the Vulkan Specification

This page is extracted from the Vulkan Specification. Fixes and changes should be made to the Specification, not directly.

Copyright (c) 2014-2020 Khronos Group. This work is licensed under a Creative Commons Attribution 4.0 International License.