C Specification

The line width is specified by the VkPipelineRasterizationStateCreateInfo::lineWidth property of the currently active pipeline, if the pipeline was not created with VK_DYNAMIC_STATE_LINE_WIDTH enabled.

Otherwise, the line width is set by calling vkCmdSetLineWidth:

void vkCmdSetLineWidth(
    VkCommandBuffer                             commandBuffer,
    float                                       lineWidth);

Parameters

  • commandBuffer is the command buffer into which the command will be recorded.

  • lineWidth is the width of rasterized line segments.

Description

Valid Usage
  • The currently bound graphics pipeline must have been created with the VK_DYNAMIC_STATE_LINE_WIDTH dynamic state enabled

  • If the wide lines feature is not enabled, lineWidth must be 1.0

Valid Usage (Implicit)
  • commandBuffer must be a valid VkCommandBuffer handle

  • commandBuffer must be in the recording state

  • The VkCommandPool that commandBuffer was allocated from must support graphics operations

Host Synchronization
  • Host access to commandBuffer must be externally synchronized

  • Host access to the VkCommandPool that commandBuffer was allocated from must be externally synchronized

Command Properties
Command Buffer Levels Render Pass Scope Supported Queue Types Pipeline Type

Primary
Secondary

Both

Graphics

See Also

Document Notes

For more information, see the Vulkan Specification at URL

This page is extracted from the Vulkan Specification. Fixes and changes should be made to the Specification, not directly.

Copyright (c) 2014-2017 Khronos Group. This work is licensed under a Creative Commons Attribution 4.0 International License.