C Specification

To set the state of an event to signaled from a device, call:

void vkCmdSetEvent(
    VkCommandBuffer                             commandBuffer,
    VkEvent                                     event,
    VkPipelineStageFlags                        stageMask);

Parameters

  • commandBuffer is the command buffer into which the command is recorded.

  • event is the event that will be signaled.

  • stageMask specifies the source stage mask used to determine when the event is signaled.

Description

When vkCmdSetEvent is submitted to a queue, it defines an execution dependency on commands that were submitted before it, and defines an event signal operation which sets the event to the signaled state.

The first synchronization scope includes every command previously submitted to the same queue, including those in the same command buffer and batch. The synchronization scope is limited to operations on the pipeline stages determined by the source stage mask specified by stageMask.

The second synchronization scope includes only the event signal operation.

If event is already in the signaled state when vkCmdSetEvent is executed on the device, then vkCmdSetEvent has no effect, no event signal operation occurs, and no execution dependency is generated.

Valid Usage
  • stageMask must not include VK_PIPELINE_STAGE_HOST_BIT

  • If the geometry shaders feature is not enabled, stageMask must not contain VK_PIPELINE_STAGE_GEOMETRY_SHADER_BIT

  • If the tessellation shaders feature is not enabled, stageMask must not contain VK_PIPELINE_STAGE_TESSELLATION_CONTROL_SHADER_BIT or VK_PIPELINE_STAGE_TESSELLATION_EVALUATION_SHADER_BIT

Valid Usage (Implicit)
  • commandBuffer must be a valid VkCommandBuffer handle

  • event must be a valid VkEvent handle

  • stageMask must be a valid combination of VkPipelineStageFlagBits values

  • stageMask must not be 0

  • commandBuffer must be in the recording state

  • The VkCommandPool that commandBuffer was allocated from must support graphics, or compute operations

  • This command must only be called outside of a render pass instance

  • Both of commandBuffer, and event must have been created, allocated, or retrieved from the same VkDevice

Host Synchronization
  • Host access to commandBuffer must be externally synchronized

  • Host access to the VkCommandPool that commandBuffer was allocated from must be externally synchronized

Command Properties
Command Buffer Levels Render Pass Scope Supported Queue Types Pipeline Type

Primary
Secondary

Outside

Graphics
compute

See Also

Document Notes

For more information, see the Vulkan Specification at URL

This page is extracted from the Vulkan Specification. Fixes and changes should be made to the Specification, not directly.

Copyright (c) 2014-2017 Khronos Group. This work is licensed under a Creative Commons Attribution 4.0 International License.